Implementing Additional Ballistic Curves - Leica GEOVID HD-B3000 Instrucciones

EN USING OTHER BALLISTICS CURVES
(only HD-B 3000)
You can add your own custom ballistics curves for
the Leica Geovid HD-B if the intended weapon/
ammunition combination is not covered by one of
the 2x12 programmed ballistics curves
. These are initially calculated precisely
EU12/US12
based on the charge data like caliber, ballistics
weight etc., which you have provided online. Then
the data is transferred to the microSD memory
card provided and can then be accessed by the
binoculars, once the card is inserted.
This is done in three steps:
A. Calculation of the required ballistics curve and
transfer to the memory card
The Leica Camera AG website at www.leica-camera.
com offers the following information in the Sport
Optics section:
– a description how to enter the required infor-
mation/values to calculate a ballistics curve
– the relevant input mask
– a description of the download procedure, i.e.
how to transfer the calculated ballistics curve
to the memory card
56
EU1/US1-
B. Inserting the memory card into the binoculars
The memory card slot
compartment
moisture.
1. Open the the battery compartment cap
turning it counter-clockwise e. g. with a coin.
2. Remove the battery.
3. Push the memory card with the contacts at
the front and bottom into the slot until you
feel it clicking into place.
4. Insert the battery so that the positive contact
goes in first (note the markings in the battery
compartment).
5. Close the cap again by turning it clockwise.
13
is located in the battery
12 to protect it against soiling and
by
9