Mounting The Center Aligner And Aligners (New Pecus / New Pecus G2) - Nogueira PTN-1000 G3 Manual De Instrucciones

4.4- Mounting the Center Aligner and Aligners on the Head
Pecus / New Pecus G2)
Normally, the aligner fingers and the central
deflector (pictured on the side) leave the head
disassembled from the factory. Mounting is
simple by fixing them with the bolts, washers
and nuts provided with the head.
NOTE!
The bolts, nuts and washers used
for this mounting are find in the kit
supplied with the head.
Fix the 2 aligner fingers with the bolts (A)
1.
and washers (B) (picture on the side).
A = Hex Bolt M10 x 30 mm (04 pcs)
B = Flat Washer Ø10 mm (04 pcs)
B = Spring Washer Ø10 mm (04 pcs)
Fix the central deflector with the bolts
2.
(C), washers (B) and nuts (D) (picture on
the side).
W = Hex Bolt M10 x 75 mm (02 pcs)
D = Spring Washer Ø10 mm (02 pcs)
D = Flat Washer Ø10 mm (04 pcs)
E = Lock Nut M10 (02 pcs)
CENTRAL DEFLECTOR
E
Instructions Manual
4. Preparation
(New
ALIGNER FINGERS
B
A
D
C
39