Balancing The Trimmer/Brushcutter; Starting / Stopping The Engine - Stihl FS 460 C-M Manual De Instrucciones

Balancing the
Trimmer/Brushcutter
The machine will balance differently
depending on the cutting attachment
mounted.
N Let the machine swing on the
harness until it stops moving –
change the connection point if
necessary
Hanging positions
Mowing heads, grass cutting blades and
brush knives should rest lightly on the
ground.
Circular saw blades should "hover"
approx. 8 in. (20 cm) above the ground.
FS 460 C-M, FS 460 C-M L
Putting down the machine in an
emergency
As soon as it becomes apparent
that a dangerous situation is
developing, the machine must be
put down quickly. Practice setting
down the machine quickly. In
order to avoid damage, when
practicing, do not throw the
machine on the ground.
Starting / Stopping the
Engine
Controls
3
2
1 Throttle trigger lockout
2 Throttle trigger
3 Stop switch with Run and Stop
positions. Push the stop switch (h)
to switch off the ignition.
Function of stop switch and ignition
system
The stop switch is normally in the Run
position: Ignition is on in this position –
the engine is ready to start and may be
started. The ignition is switched off when
the stop switch is depressed. It is
automatically switched on again after
the engine comes to a standstill.
English
1
27