Technical Specifications Of The Titrator Titroline ® 7000; Notes To The Operating Manual; Intended Use - Xylem TitroLine 7000 Manual De Instrucciones

1 Technical Specifications of the Titrator TitroLine
1.1

Notes to the operating manual

The provided operating manual will allow you the proper and safe handling of the product. For maximum security,
observe the safety and warning instructions in the operating manual!
Warning of a general danger:
Non-compliance results (can result) in injury or material damage.
Important information for device use.
 Refers to another part of the operating manual.
The menu screens shown in this operating manual serve as an example and may differ from what you see!
1.2

Intended Use

®
The TitroLine 7000 is a potentiometric titrator and suitable for pH, mV, µA titrations with a maximum of 50
memorisable methods.
The examples of possible use include:

Acid and base determination in aqueous solutions such as p and m value, titration of strong and weak
acids and bases

Redox titrations such as iodometry, manganometry, chromatometry, and COD determinations,
other mV titrations, e.g. chloride

Titrations using ion-selective electrodes, e.g. calcium, fluoride, copper, lead ions

Indices such as OH number, iodine number, and saponification number

Reading out and saving the calibration data from SI Analytics

Titration up to two inflection points examined as the titration of calcium and magnesium

pH-Stat titrations

Non-aqueous potentiometric titrations such as TAN and TBN

Pre-dosing with a connected piston burette

Connection and use of an autosampler TW alpha plus/TW 7400

Compatibility with TitriSoft from Version 3.3
In addition, the TitroLine

Manual titrations with or without calculation of the result

Dosing

Preparation of solutions
Each method allows for the setting of a variety of dosing and filling rates.
Solutions to be used:
Virtually, any liquids and solutions with a viscosity of < = 10 mm²/s such as concentrated sulphuric acid may be
used.
However, one has to avoid the use of chemicals that may attack glass, PTFE or FEP or that are explosive,
such as hydrofluoric acid, sodium azide or bromine! Suspensions containing high solids percentages may clog or
even damage the dosing system.
Do not use the device in hazardous locations!
General:
The safety guidelines that are applicable to the handling of chemicals have to be observed under all
circumstances. This applies in particular to inflammable and/or etching liquids.
®
7000 comes with the functionalities of the TITRONIC
®
7000
®
ID electrodes.
®
500 piston burette:
127