Combination With Accessories And Additional Devices; Connecting A Printer; Connecting A Usb Device; Connection Of Analytical Balances - Xylem TitroLine 7000 Manual De Instrucciones

144
Fig. 27
The interchangeable unit and the cylinder size have to correspond. Otherwise the coding, which is memorized
within the interchangeable unit will no longer match the cylinder size. This will trigger incorrect dosage.
For the sake of dosing and analytical accuracy, it is also recommended to replace the PTFE piston each time
a defective glass cylinder is replaced. Broken glass may damage the sealing rings of the PTFE piston.
2.10

Combination with Accessories and Additional Devices

Connecting a printer

2.10.1
Printers with a USB interface are to be connected to one of the two USB-A interfaces.
These printers have to feature HP PCL emulation (3, 3 enhanced, 5, 5e).
So-called GDI printers cannot be used!
Alternatively the thermo-compact printer Seiko S445 can be connected.

Connecting a USB device

2.10.2
The following USB devices can be connected to the USB-A interfaces:

PC-keyboard

TZ 3880 manual controller

Printer

USB storage devices, e.g. USB sticks

USB-Hub

USB barcode scanners

Connection of analytical balances

2.10.3
Analytical balances are to be connected to the RS232-2 using an appropriate cable.

Connection of SI Analytics

2.10.4
The connector of the ID electrode contains a bead. This bead can be used as a marker for connecting the
electrode to the mV/pH socket. The bead should possibly point upward to the reference socket or in between
(also refer to Fig. 1). The identification of the ID electrode is thereby simplified. Data of the connected ID
electrode are read out immediately after the connection and stored in the titrator. This includes the calibrating
data, such as zero point and slope, date of the calibration, buffer solutions used, the serial number and type of
electrode.
®

ID electrodes