To Set Machine Parameters - FAS FASTER GCD Manual Del Usuario

24
N.B.: with the SPIRAL SLAVE connection enabled (see Command 49), after setting the MASTER machine,
the same parameters for the SLAVE machine can be set.
This option is only available on FASTER SLAVE vending machines
9.1.3

TO SET MACHINE PARAMETERS

Command 49 Enabling/Disabling spirali slave:
This command enables the master/slave connection. It is possible to connect one slave snack machine.
Command 40 must be set after the connected slave machine has been enabled.
To run a Stand-Alone as a Slave:
E
N
G
•
Switch off the machine by means of the main switch and pull out the power plug.
L
•
Disconnect the connector from the socket JP11A from the main board.
I
S
H
•
Make the Master/Slave connection
by means of the serial cable, fitting
the connectors to the sockets on the
rear.
•
Nominate the machine by means of
the dip-switch on the electrical panel,
positioning the notch in the respective
position as in the figure below. To
access the electrical panel, see the
paragraph:
ELECTRICAL
COOLING UNIT.
turn on again, and carry out the programming of the Master machine.
Command 50 Machine configuration (number of selections/ pusher drawers/drive time-out)
This command lets you memorize the number of selections (gearmotors) in the machine. As a consequence,
every time the machine it turned on, a comparison is made between the memorized configuration and the
detected one, and any discrepancy will be indicated on the display. The configuration command must be
executed every time a modification is made to the machine that envisages the addition or elimination of
gearmotors.
The next step allows you to configure the pusher drawers. It is sufficient to enter the drawer number, 1–7,
starting from the top and setting the parameter to 1. (ATTENTION: the parameter must be set at zero if the
pusher drawer is replaced by a spiral drawer).
In the case of pusher drawers you are also asked to enter the product thickness in millimetres for every
selection. This is a safety expedient in case of failure of the product drop photocell and translates into a
gearmotor operation time-out (selection 99 makes it possible to set a simultaneous time-out for all the
selections).
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
For the machine to function correctly the drawers to be set with the refrigeration unit safety
device must be located
CHARACTERISTICS).
ACCESS TO THE
PANEL AND
inside the 3°C area
FASTER GCD – Issue 03
(see paragr. TECHNICAL