Access To The Electric Panel And Refrigeration Unit - FAS FASTER GCD Manual Del Usuario

FASTER GCD – Issue 03
•
Put one spiral + motor unit aside and in the other one replace the spiral with small diameter with a spiral
with large diameter.
•
Remove the divider det.2.
•
Insert the tray det.3.
•
Insert the spiral with large diameter + motor unit in the central slot of the support det. 4.
•
Install the new price and selection plates.
•
Insert the modified tray and make sure that the connector is plugged in.
•
Programme the new selections at the desired sale price. NOTE: In the large space selections, the
selection numbers are odd numbers. E.G.: Selections A 1 and A 2 converted to a single
compartment become a single selection A 1.
•
Test the new selections to ensure that they work correctly.
10.8

ACCESS TO THE ELECTRIC PANEL AND REFRIGERATION UNIT

To access the electric panel or the refrigeration unit proceed as follows:
•
Switch off the machine by means of the main switch and pull out the power plug.
•
Open the door.
•
Use a phillips screwdriver to undo the two screws that fasten the product collection pocket to the cabinet.
Remove the pocket.
•
To remove the refrigeration unit, lower the two levers located on the side of the evaporator box, ensure
that the gasket positioned on the top edge of the evaporator box is not attached to its lodging, pull the
special handle. CAUTION : beware of the cables.
Electric panel: When the product collection pocket is removed the entire vending
machine remains energised. To disconnect the power remove the red key inserted in the
terminal board. Total isolation from the electric power supply is only obtained when the
plug is removed from the external magnetothermal switch. Consequently, all operations
required by the vending machine without the protection of the product collection pocket,
must only be carried out by qualified personnel who are aware of the specific hazards
which this condition involves.
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
45
E
N
G
L
I
S
H