To Set Machine Parameters - FAS BABY Manual De Instrucciones

BABY FAS – Issue 04
8.3.2

TO SET MACHINE PARAMETERS

Command 50 See paragraph 7.6.3.
Command 58 Diagnostic level:
To set the following option ONLY, enter the "programming mode" and when the
message "command 00" appears on the display press the "test" button again for a
further 3 seconds, after which the buzzer will sound again for a few seconds, and
access to the second level of the menu is obtained. The message "Command 00" will
appear again. To quit the programming mode press the "A" key .
The command can be set at 0 or 1. If the command is set at 1, in the event the selected spiral does not
complete the whole rotation, that selection goes out of order. Whereas if the command is set at 0 - the
default value - it does not go out of order.
Command 59 Entering the code for sales counter display:
This command is used for storing a 6-character code composed from any combination of the "A" and "B"
keys. When the machine is in stand-by and this code is keyed in the value of the sales number counter
which cannot be reset (see Command 09) is displayed for approximately 6 seconds on the screen.
Example:
1. Programming mode, display shows............................................................................................ Command 00
2. Key in 59 + key "B", display shows...........................................................................................Code 000000
3. Key in "B", display shows .......................................................................................................... Code _00000
4. Key in the desired combination of the characters "A" and "B" ................................................Code ABBAB_
5. When the sixth character is entered the code is stored and the display shows.......................------ OK -------
N.B. If key "A" is selected in point 3, the main menu of the programme is called up and the code remains
unaltered.
If a 0 is selected in point 4, the code is completely zeroed and the relevant function impossible to
activate.
Command 60 Memory erasure:
Activation of this command cancels all the data programmed by the user and the
new default parameters determined by the manufacturer are automatically set.
This command will display the message "Code 0000". All data stored in the memory of the machine will be
erased by typing in code 6203 and pressing the B button. This function must be used very carefully to avoid
the accidental loss of all data. Electronically the machine is as new. The message "memory cleared"
appears on the display. The procedure for erasing the memory is as follows:
1. Go into programming mode to display .................................................................................._Command 00_
2. Key in 60 and press the B button to display .............................................................................. _Code 0000_
3. Key in 6203 and press the B button to display ...................................................................._memory cleared
To exit the command press the "test" push button once.
Command 61 Resets the security/access code:
Allows the access code used in the EVA_DTS protocol to be reset.
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
23
E
N
G
L
I
S
H