Festool WTS 150/7 E Manual De Instrucciones Original página 10

Eccentric sander
Technical data
Power
Speed
Sanding stroke
Weight (excluding cable)
Degree of protection
The specifi ed illustrations can be found at the
beginning of the operating instructions.
Symbols
Warning of general danger
Wear a dust mask!
Wear protective goggles!
Read the Operating Instructions/Notes!
Wear ear protection!
1 Intended use
As specifi ed, the machines are designed for sand-
ing and polishing wood, plastic, metal, stone,
composite materials, paint/varnish, filler and
similar materials. Materials containing asbestos
must not be processed. For reasons of electrical
safety the machine must not be damp nor oper-
ated in a humid environment. The machine may
only be used for dry sanding.
The user is liable for damage and injury
resulting from incorrect usage!
2 Safety instructions
WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings
and instructions may result in electric shock, fi re
and/or serious injury.
Save all warnings and instructions for future
reference.
The term „power tool" in the warnings refers
to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
- Harmful/toxic dusts can occur during your work
(e.g. lead-containing paint, some types of wood
and metal). Contact with these dusts, espe-
cially inhaling them, can represent a hazard for
operating personnel or persons in the vicinity.
Comply with the safety regulations that apply in
WTS 150/7 E your country. Connect the electric power tool to
500 W a suitable extraction system.
2000 - 6000 rpm
7 mm
1.9 kg
/ II
- The manufacturer's handling and processing
instructions must be observed without fail if
explosive or self-igniting dusts are likely to oc-
cur during sanding.
3
The typical values determined in accordance with
EN 60745 are:
Sound pressure level
Sound-power level
Measuring uncertainty allowance
Overall vibration levels a
directions) measured in accordance with EN
60745:
Handle
Auxiliary handle
The emission values specifi ed (vibration, noise)
were measured in accordance with the test con-
ditions stipulated in EN 60745 and are intended
for machine comparisons. They are also used for
making preliminary estimates regarding vibration
and noise loads during operation. The emission
values specifi ed refer to the main applications for
which the power tool is used. If the electric power
tool is used for other applications, with other tools
or is not maintained suffi ciently prior to opera-
tion, however, the vibration and noise load may be
higher when the tool is used. Take into account any
machine idling times and downtimes to estimate
these values more accurately for a specifi ed time
period. This may signifi cantly reduce the load dur-
ing the machine operating period.
4
To switch on, push the switch (1.3) forwards until
it engages. Pressing the back end of the switch is
suffi cient to release the switch-on lock and switch
the machine off.
10
To protect your health, wear a P2 protec-
tive mask.
Always wear protective goggles because
of possible dangers when sanding.
Noise and vibration information
Wear ear protection!
(vector sum for three
h
Power supply and start-up
The mains voltage must correspond to
the specifi cation on the rating plate.
82 dB(A)
93 dB(A)
K = 3 dB
a = 4,5 m/s²
h
K = 2,0 m/s²
a = 6,5 m/s²
h
K = 2,0 m/s²