Air Supply; Installation - Jøtul F 305 Long legs Instrucciones Para Instalación

ENGLISH

Air supply

The amount of combustion air for Jøtul's products is approximately
20-40 m 3 /h. The outside air connection may be fitted directly to
the Jøtul F 305 through:
• the bottom
• through a flexible supply hose from the outside/chimney
(only if the chimney has its own duct for external air) and to
the product's outside air connector.
Fig. 2A, through an outside wall
Fig. 2B, through the floor and ground plate
Fig. 2C, through the floor and basement
Fig. 2D, indirectly through an outside wall
8

4.0 Installation

NB: Check that the fireplace is undamaged before installation
begins.
NB: The product is heavy! Ensure you have help when
positioning and installing it. Make sure the product does
not topple over.
NB: Do not place anything on the top plate of the stove as this
could cause permanent damage to the paint.
NB: Read the Installation and Operating instructions carefully
before installing the fireplace!
4.1 Prior to installation - Jøtul F 305
with legs
NB: There are two different legs. See the figure (fig. 6) on
the bottom plate for correct placement.
Fig. 3
A
1. Remove the four transport screws (A) that fasten the oven
to the wooden pallet.
2. Leave the stove standing on the transport pallet.
3. Remove the gloves from the ash pan.
4. Lift the baffle, ash retainer, inner bottom and bag of screws
out of the burn chamber.
5. Check that the control handles (C) move freely.
C
A