Chapter 3: The Radio; Listening To The Radio - Sony CHC-P33D Manual De Instrucciones

Chapter 3:
the
Radio

Listening to the Radio

Presetting Radio Stations
Playing Preset Radio
Stations
EN
10

Chapter 3: the Radio

Listening to the
Radio
When you want to play a radio
programme, you can have the tuner
automatically scan the radio frequencies
and tune in the stations with clear signals.
This feature saves you time in searching for
stations with clear signals.
However, stations with weak signals may
be skipped by automatic tuning. Manually
tune in the ones skipped by automatic
tuning.
2
STEREO/MONO
BAND
1
Press TUNER/BAND (or BAND on the
remote) repeatedly until the band you
want appears in the display.
As you press TUNER/BAND, the band
changes as follows:
Latin-American and Australian
models:
FM AM
Other models:
FM MW SW
2
Press TUNING MODE repeatedly until
"AUTO" appears in the display.
3
Turn the jog dial clockwise to scan a
higher frequency station. To tune in a
lower frequency station, turn the jog dial
counterclockwise.
The tuner starts scanning radio
frequencies automatically, and stops
when it finds a clear station.
"TUNED" appears in the display.
"STEREO" also appears if the FM
station tuned is broadcasting in stereo.
4
If you do not want to listen to the station
selected, turn the jog dial again to restart
the scan.
When the desired station is not
1
tuned in
Automatic tuning may skip the station with
a weak signal. Tune in the station
3,4 manually.
1 Press TUNING MODE repeatedly until
"MANUAL" appears in the display.
2 Keep turning the jog dial until the
desired station is tuned in.
To improve MW/SW (AM) broadcast
reception
Reorient the supplied AM loop aerial for
MW/SW (AM).
MW/SW (AM)
To change the MW(AM) tuning
interval(except for the Middle
Eastern model)
The MW(AM) tuning intervals is preset to
9 kHz in the factory. If you need to change
the interval to 10 kHz, do as follows:
1 Turn on the power.
2 Change the band to MW(AM).
3 Turn off the power.
4 Press TUNER/BAND while pressing
FUNCTION.
After changing the MW(AM) tuning
interval, reset the MW(AM) preset radio
stations. To reset the interval to the factory
setting, follow the same procedure.
When an FM programme is not clear to
receive
Press STEREO/MONO so that "MONO"
appears in the display. There will be no
stereo effect, but the reception will
improve. Press STEREO/MONO again to
restore the stereo effect.