Installing The Speakers - Sony CHC-P33D Manual De Instrucciones

AM loop aerial
FM lead aerial
STEP 4
to a wall outlet
Do this connection last!
STEP3 Adjusting the
Operating Voltage (except
for Australian model)
Before connecting the power, set
VOLTAGE SELECTOR to the position of
the local power line voltage.
VOLTAGE SELECTOR
220V 110V
-240V -120V
STEP4 Connecting the
Power
Connect the mains lead to a wall outlet
after you have made all the above
connections.
Right satellite speaker
STEP 3
STEP 2
STEP 1
Plug Adaptor
If the plug on this unit does not fit your
wall outlet, remove the plug adaptor
attached to the plug (except for Latin
American countries and Australia).
Installing the
Speakers
Proper speaker positioning is essential in
order to achieve directional effects and
diffused ambience.
When you install the speakers, refer to the
following instructions.
Once you have determined the final
placement, fasten the speakers to the
speaker stands.
Note
Do not install the woofer close to the unit,
and do not place the woofer above or below
the unit. Otherwise, the vibration from the
woofer may cause mechanical noise or
"skipping".
When installing the speakers on
either side of the main unit
to a wall
Place the superwoofer between the two
outlet
satellite speakers.
Superwoofer
When installing the satellite
speakers away the superwoofer
1 Insert the supplied stand into the rear of
the superwoofer.
2 Install the superwoofer between the
satellite speakers with its front panel
facing upward.
When installing the satellite
speakers away from each other
Position the satellite speakers so they face
toward your listening position.
Chapter 1: Setting up
Left satellite speaker
EN
5