Recording - Sony SVT-DL224 Manual De Instrucciones

Recording

This section shows you how to record the signal from
the video camera in the normal or time lapse mode, to
set the security lock and to record repeatedly on the
same cassette.
1 2
1
Turn on the power of the equipment to be used.
2
Insert the cassette.
3
Set the recording speed by pressing TAPE SPEED.
Recording Maximum recording
speed time with 160-minute
tape (hour)
8 EP mode 8
24 Time lapse 24
mode
In the display window
4
Press REC r.
Recording starts.
To stop recording
Press STOP p.
If recording does not start and the cassette is
ejected
The tab on the cassette is removed to protect against
accidental recording.
3 4
STOP p
Interval Audio Tape
(sec.) recording motion
1/60 Possible Continuous
1/20
Recording speed
Notes
• The recording speed indication shows the maximum
recording time when you use the T-160 cassette tape.
The maximum recording time depends on your
cassette tape as following table:
Recording speed Maximum recording time (Hour)
indication T-120 Cassette
8 6
24 18
• This VCR records the picture in the EP mode though
you set the recording speed to "8".
This VCR cannot record in the SP mode.
• Whenever you insert a tape and first start recording,
Adaptive Picture Control (APC) automatically
improves recording quality by adjusting the VCR to
the condition of the video heads and tape. There is
about a 6-seconds delay before the VCR actually
starts recording when REC r is pressed.
• This VCR is provided with a clog detection function.
In time lapse modes, if recording is not made
properly, the recording indicator will flash on the
display window and a warning signal will be output
from the WARNING OUT terminal. In this case, stop
recording immediately and check the VCR.
T-60 Cassette
3
9
13