Look C0264 616 / MY 08 Manual De Instrucciones página 22

GB
1/ Cutting the seatpost
to its height
1 – On the seatpost: Check that the 3
preinstalled spacers are in place
2 – Insert the seatpost inside the frame and
adjust the horizontal position of the seat.
Use the previous position (FRONT/BACK)
(seat backwards movement)
4 – Tighten the seat carriage to the
recommended torque of 22 Nm
5 – Measure the height «B» of your new
cycle (Picture 1)
6 – Calculate the cut length «L» using the
formula: L = B - A (new seat height – old
seat height)
7 – Remove the seatpost
8 – Install the template:
Put the template at height «L» measured
from the saw cut and the top of the seat tube
(Picture 2).
9 – Tighten the template in position with the
transverse screw (Picture 3)
10 – Cut the tube to length, inserting the saw
(24 or 32 teeth / inch) in the saw cut (saw in
the vertical position) (Photo 4).
11 – Take the template off and deburr the end
of the tube. Make sure that the end of the
tube is clean and free of paint.
42
Picture 2
Picture 3
Picture 4
2/ Installing the seatpost
in the frame
1 – Make sure that the seatpost screw is
loose (the screw must still be threaded
but the elastic rings expander must not be
clamped).
2 – Adjust the height (possible every 1.25 mm
from 0 to 32,5 mm): choose the combination
of spacers among the 6 parts provided (see
table on facing page that summarizes all
possibilities) and fit the chosen spacers
under the shoulder of the seatpost. Keep at
least the following three parts.
(E-Post delivered in this configuration)
Support
washer
Elastomer
Other spacers may be added depending on
your required adjustment height
3 – Insert the seatpost in the seat tube
and position it to the stop at the top of the
connector.
4 – Tighten the seatpost screw (4 mm Allen
key to torque of 5 Nm). (Picture 5)
GB
Photo 5
43