Look C0264 616 / MY 08 Manual De Instrucciones página 20

GB
E-POST R5 / E-POST R32 :
Seat assembly on post
A
B
A: Tapped plate
B: Conical cup with marks
C: Conical cup
D: Plate to be screwed
E: Screw
38
E
D
C
E-Post R5
1 - Place both nuts on seat post head. Use mark < engraved on conical
cup B to align part with seat post reference marks.
2 - While holding both conical cups, make seat rails slide into conical
cups grooves.
3 - Slightly lubricate threading and the lower part of screw E head. Pass
the screw through the plate to be screwed and the two conical cups
E
positioned on the seat.
D
4 - Place threaded plate A at the end of the screw so that the grooves
are aligned with the seat rail.
A
5 - Screw screw E onto the threaded plate using a 5mm hollow spanner
for hexagon nuts.
6 - Before final tightening of the screw, adjust the angle and position of
the seat as desired.
7 - Tighten the assembly using screw E to the recommended torque of
17N/m, using a 5mm hollow spanner for hexagon nuts.
GB
39