Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
6. INSTALL CUSTOM HOOD LINER (OPTIONAL)
The liners are specially designed to protect the exterior base of the custom hood. To order, refer to the table below to find the
right liner model number for your insert and width of custom hood. To view specific model information, including depths for each
liner models, visit www.bestbybroan.com or contact Technical support (phone number listed on page 14, in warranty text).
To install, see instruction packed with custom hood liner.
The liner must be installed before the insert.
NOTE: On some liners models, front liner piece may overlap front insert flange. If so, remove the front liner piece, assemble
insert, and reassemble front liner piece.
LINER MODEL
L3336S
L3342S
L4548S
L4554S
L4560S
7. INSTALL THE WCPI REMOTE CONTROL (OPTIONAL)
The electrical connection for the remote control is located in front of the
insert. Perform this connection before the insert installation.
For installation details, see installation instructions included with the
WCPI remote control.
8. CUT THE HOLE IN CUSTOM HOOD BASE
If it is not done yet, cut a hole in the bottom of the cabinet, using the dimensions
shown beside.
INSERT MODEL NUMBER
PIK33
PIK45
NOTES: 1. The notch shown in the inset must be cut only if the WCPI
optional remote control will be installed.
2. The recommended distance from the back to the rearmost
cutout edge is 2¼'' minimum.
9. INSTALL BLOWER (INTERIOR OR EXTERIOR BLOWER)
INTERIOR BLOWER: Follow all subsequent steps of this manual.
EXTERIOR BLOWER: Refer to instructions packed with exterior blower and follow steps 13, 14, 16, 17, 19 and up of this manual.
INSERT MODEL
CUSTOM HOOD
NOMINAL WIDTH
PIK33
PIK33
PIK45
PIK45
PIK45
A
32½''
44½''
36''
42''
48''
54''
60''
HA0038A
- 7 -
HL0044
17 1/16''
2 1/4''
min.
HD0084
3 1/2''
16 3/8''
A
Publicidad
Tabla de contenido
