Bricks; Installing Sanding Belts; Attaching Polishing Tools; Switching On And Off / Adjusting The Speed - Parkside PFBS 160 A1 Instrucciones De Utilización Y De Seguridad

Use the combination wrench
screw on the clamping mandrel.

Bricks

Firmly secure the whetstone! Use a vice or equiv-
alent tool to prevent injuries.
When using the bricks for the first time, they must
first be trimmed using the prismatic whetstone.
To do so, slowly bring the brick
stone with the tool switched on. Grinding the two
abrasive wheels together will remove uneven
areas in the contour of the brick. The whetstone
can further be used to shape the brick.

Installing sanding belts

Slide the grinding belt
mandrel from the top. Tighten the screw on
34
the grinding mandrel
belt .
24

Attaching polishing tools

Screw the polishing tool
mandrel for polishing attachments
Switching on and off / Adjusting
the speed
Switching on / adjusting the speed:
Set the ON / OFF switch
pressing down and sliding it forward.
Set the variable speed control
between „1" and „6".
Switching off:
Set the ON / OFF switch
to tighten the
33
to the whet-
23
onto the grinding
24
to secure the grinding
34
into the tip of the
22
.
25
to position „I" by
1
to a position
10
to position „0".
1
Information about processing
materials / tool / speed range
Use the router bits to process steel and iron at
maximum speed.
Determine the speed range for processing zinc,
zinc alloys, aluminium, copper and lead by
testing scrap pieces.
Process plastics and materials with a low melt-
ing point at a low speed.
Process wood at high speeds.
Clean, polish and buff at a medium speed.
The following information are non-binding recom-
mendations. When performing the actual work also
test yourself, which tools and settings are ideal for
the material you are working on.
Start-up
GB/MT 41