Kit Assembly - Metra 95-8904B Instrucciones De Instalación

ISO DDIN radio provision
1. Attach the ISO DDIN brackets to the ISO
DDIN trim plate. (Figure A)
2. Slide the radio into the bracket/radio
housing assembly and secure the
radio to the assembly using the screws
supplied with the radio. (Figure B)
3. Using an air saw, hacksaw, or similar
cutting tool, cut to the inside of the
radio's lower mounting holes, through
the plastic and metal bracket. (Figure C)
Note: Cut on the inside of each hole as
close to the hole as you can get. If cut
properly you may re-use two bottom
factory screws, if not use self tapping
screws on the bottom.
4. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to the
radio. Metra recommends using the proper
mating adapter from Metra and/or AXXESS.
Test the radio for proper operation .
5. Reassemble the dash in reverse order of
disassembly.

KIT ASSEMBLY

(Figure A) (Figure B) (Figure C)
REV. 9/19/2017 INST95-8904B
3