V2 CITY1-ECD Manual Del Usuario página 39

Cuadro de maniobras digital para cancelas batientes y puertas correderas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Lock time
Before the opening phase begins, the control unit will energize the
electric lock in order to release it and enable the gate motion.
t.SEr time will fix the energizing time.
WARNING: in case the gate has no electric lock, set the
value 0 ('no' will appear on display).
Silent Locking Mode
This menu allows you to select the silent operation mode for the electric
lock.
Si
Silent Mode (140 Hz)
no
Standard Mode (50 Hz)
CAUTION: In silent mode, the voltage supplied to the lock
has a higher frequency in order to make the locking less noisy.
In some cases, there may be problems when unlocking. If
problems should occur, select the Standard mode.
Lock advance time
While the electric lock is energized, the gate will stay standstill for t.ASE
time, to make its release easier.
In case t.ASE is lower than t.SEr, the lock energizing will go on while
the doors will start moving.
WARNING: in case the gate has no electric lock, set the value 0
Backlash time
It could be useful to give a closing command to motors, to help the
electric lock release.
The control unit controls the motors in reduced power in closing
direction for the setup time.
The backlash precedes the electric lock release. It is possible to reverse the
order by setting a lock advance time higher then the backlash one.
WARNING: in case the gate has no electric lock, set the value 0
Pre-blinking time
Before any gate movement, blinker will be activated for t.PrE time, to
warn about the incoming motion.
37

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

City1-ecd-120v

Tabla de contenido