Spare Parts - Peltor Twin Cup MT7 H540 Serie Manual Del Usuario

Note: The maximum output effect of the earphones must
not be exceeded.
Sound level at 0.5 V/1 kHz: 81 dBA
Max output, continuous: 30 mW
short-term: 100 mW
(E) ATTENUATION VALUES:
The headset is tested and approved according to PPE
directive 89/686/EEC and applicable parts of European
standard EN 352-1:1993, EN 352-3:1993 and EN 352-
6:2002. EC type examination certificate issued by the
Department of Physics, Finnish Institute of Occupational
Health, Topeliuksenkatu 41 A, FI-00250 Helsinki, Finland.
ID#0403.
Explanation of the attenuation value table:
1) Frequency in Hz.
2) Average attenuation value in dB.
3) Standard deviation in dB.
4) Average Protection Value.
For the best protection, brush aside hair around the ears
so the ear cushions fit snugly against the head. Spectacle
frames should be as thin as possible and fit close to the
head.
ACCESSORIES
FL5000 Adapter
For connection to the most common models of
communication equipment.
MT9 Throat mike
Connects easily to the MT7H540F and MT7H540P3E via a
connector if a boom microphone is not desired.
HYM1000 Mike Protector
Moisture and wind-tight and hygienic; protects the
microphone and enhances its life span. Packages of 5
metres, approx. 50 replacements.
Wind protection M40/1 for the MT70 microphone
Effective protection from wind hiss. Increases the life span
and protects the microphone. One per package.
Clean – single-use protectors – HY100A
Hygienic single-use protector that is easy to apply to the
ear cushions. Packages of 100 pairs.
TKFL01 attachment clamp
Used where necessary to attach the equipment cord to the
user's clothing.
Storage bag for headset FP9007
Protects your headset during transport and storage.

SPARE PARTS

HY13 hygiene kit
Easy-to-replace hygiene kit for headsets. Consists of two
attenuation cushions and snap-in ear cushions. Should
be replaced often to ensure constant attenuation, good
hygiene and comfort. If the headset is used continuously,
replace at least twice a year.
MT70 Microphone
Complete microphone arm with dynamic mike for
connection to an MT7H540*-type headset.
3