Spare Parts - Peltor HT 79 Serie Manual De Instrucciones

• Clean the outside of the headset regularly with soap and warm
water. Note: Do not immerse in fluids!
• Despite its quality, the hearing protector telephone can wear
out over time. Inspect it regularly to ensure that there are no
cracks or sound leakage, which will reduce its function.
If used continuously, check the sealing rings often.
• Do not store the headset in temperatures exceeding +55°C,
for example in a windscreen or window.
• Certain chemical substances may be harmful to this product.
Contact the manufacturer for more information.
(F) Period of use/Input signal
Warning: The sound level from the earphones in this hear-
ing protector can lead to a daily exposure that exceeds the
permitted levels. The audio signal in the earphones must
therefore be adapted to the usage time. To prevent harmful
levels, the input signal should not exceed 370 mV. At a higher
input voltage, the usage time must be decreased according
to diagram D: (x = 370 mV). An electrical input signal level
of 370 mV corresponds to 8 dB (A) equivalent sound level
(average value plus one standard deviation of the measured
sound level. See table D:).
Note: The maximum output effect of the earphones must not
be exceeded.
Sound level at 0.5 V/ kHz: 8 dBA
Max output, continuous: 30 mW
short-term: 00 mW
(G) Attenuation values
The hearing protector telephone is tested and approved according
to PPE directive 89/686/EEC and applicable parts of the European
EN 352-1:1993 standard. Attenuation values from the test report for
the 95199S02 certificate (EC type examination certificate) issued by
the Department of Physics, Finnish Institute of Occupational Health,
Topeliuksenkatu 41, FI-00250 Helsinki, Finland, ID# 0403.
Explanation of the attenuation value table: 1) Frequency in Hz. 2)
Average attenuation in dB. 3) Standard deviation in dB. 4) Average
Protection Value.
ACCESSORIES
Not intended for use in Ex-classified areas
Stereo extension cord, Ø 1/4" connector
FL1A 0.4–2 m spiral PU
Stereo extension cord with Ø 3.5 mm connector
FL1I 0.3–0.9 m spiral PU
HY100A single-use protector
Hygienic single-use protector that is easy to apply to the sealing
rings. Packages of 100 pairs.

SPARE PARTS

HY79 hygiene kit
Easy to replace hygiene kit for hearing protector telephones. Consists
of two sets of attenuating cushions and snap-in sealing rings.
Should be replaced often to ensure constant attenuation, good
hygiene and comfort.
For continuous use, replace at least twice a year.
TKFL01 Attachment clamp
Used when necessary to attach the cord to your clothes.
3