SATA AE1015 Manual De Instrucciones página 59

Fig7-17
Install the manual valve box assembly at the fixing hole on the side of tumbler and tighten it with bolts as shown in Fig. 7-17: Apply the
special grease of tire changer on the removed tire as shown in Fig. 7-18, and clear the rim with the brush.
Fig7-19
Place the head on the rim, tighten the hexagonal shaft, place the bead above the tail, press the pedal of chassis to rotate the turntable and
install the first layer of tire as shown in Fig. 7-19; adjust the tire-pressing roller of auxiliary arm to be tangent to the rim, and tighten the
tire-pressing roller wrench to maintain its stability as shown in Fig. 7-20.1; then tighten the fixing pin of the auxiliary arm tumbler as shown
in Fig. 7-20.2; and then move the manual valve of auxiliary arm downwards so that the tire-pressing roller is pressing the tire below the
disengaging port (the specific position subject to the actual tire changing condition), press the pedal of chassis and rotate the plate. The
tire is mounted well after the bead is completely loaded into the rim.
AE1015/AE1015-3/AE1015H/AE1015H-3
中文
EN
Fig. 7-18
Fig. 7-20
DE RU KO PT JA ES
59