Assembly Instructions - Kobalt SGY-AIR70NB Manual Del Usuario

ASSEMBLY INSTRUCTIONS

1. Tighten female plug (not included)
clockwise with a wrench (not included) for
air tight connection (See Figure 1).
DO NOT OVERTIGHTEN.
NOTE: Use threaded sealant tape
(not included) on the threading of the
male plug on the bottom of the spray gun.
NOTE: As an option, you can connect an Air Pressure
Regulator to the bottom of the spray gun and then
attach the female plug to the bottom of the air
pressure regulator.
2. Determine proper Air Cap (C or K) for current
project.
Internal Mix - Generally used with slow drying, heavy
bodied latex paints and for faster material application.
NOT to be used with fast drying latex paints which will
clog the opening in the air cap. Internal mix caps must
be used with pressure feed operation.
External Mix - Used for quick drying, light bodied latex
paints. Better for fine finish work. These caps can be
used with either siphon or pressure feed.
3. Attach the Air Cap (C or K) with Air Cap
Ring (H or K) to front of gun by turning it
clockwise.
4. Turn the Siphon/Pressure Knob (F) to proper setting.
, turning
10
1
2
Internal mix
air cap
external mix air cap
3
K
4
F
G
K
C
C
F
P
S