Kit Assembly - Metra 95-890 Instrucciones De Instalación

ISO DDIN radio provision
1. Clip the climate control into the
back of the 95-8901. (Figure A)
2. Attach the hazard switch to the
radio housing trim panel with the
supplied (1) #8 x 3/8" Phillips
screw supplied. (Figure A)
3. Attach the radio brackets to the
radio housing trim panel using
the (4) #8 x 3/8" Phillips screws
supplied. (Figure B)
4. Secure the climate control to the
brackets using the factory screws.
(Figure C)

Kit Assembly

(Figure A)
(Figure B)
95-8901
5. Slide the radio into the bracket/
radio housing trim panel assembly
and secure to the assembly using
the screws supplied with the radio.
(Figure D)
6. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS.
Re-connect the negative battery
terminal and test the unit for
proper operation.
7. Reassemble dash in reverse order
of disassembly.
3
(Figure C)
(Figure D)