Installation Instructions - Volkswagen LogBox 5GV 051 629 Manual De Montaje

Installation Instructions

Genuine LogBox
Scope of delivery:
1 x LogBox
◆
1 x wiring harness
◆
Assorted fitting material
◆
1)
the software (app) required for the use of the LogBox in conjunction with a smartphone can be downloaded from the internet. Additional
information may be found in the operating instructions "Genuine Apps for LogBox". The attached operating instructions must be passed
on to the customer on handing over the vehicle.
Installation process:
Note
The installation of the LogBox must be carried out by a competent workshop. Special tools are needed for the
◆
installation as well as detailed, vehicle-specific manuals. Incorrect fitting may lead to damage to the vehicle or the
supplied components.
The work to be performed, as described in these installation instructions, may vary in some circumstances as a
◆
result of model improvement measures. As such, changes to the wiring colours or even the fitting locations cannot
be discounted. In view of this, please ensure that you always use the appropriate current circuit diagram or the
current vehicle workshop manual.
Secure the wires so that they cannot come into contact with any moving parts and so that they cannot chafe on
◆
any metal edges.
Only the original German version is definitive. No liability is assumed for translation errors. Subject to technical
◆
modifications.
1.1 Preparation work on the vehicle
Die LogBox should preferably be installed behind the the left-hand side dash panel cover (
installation in the radio installation bay is also possible (
-J533- ( 1.3).
In driving school vehicles the LogBox must be installed in the radio installation bay (
additionally connected to the connector plug of the additional pedals (
Remove the dash panel cover and storage compartment on the driver's side.
ELSA; repair group 68
Note
The parts on the driver's side must be removed in order to establish access to the data bus diagnostic interface -J533-.
Depending on the vehicle model and accessories it may be necessary to remove additional vehicle parts, such as the air
vent ELSA.
1.2 Installing the LogBox
1.2a Fitting behind the left-hand side dash panel cover:
Note
Fitting behind the left-hand side dash panel cover is not possible for driving school vehicles (due to cable length),
◆
it must be fitted in the radio installation bay (
Should there be insufficient space behind the the side dash panel cover, for instance if accessories have been
◆
previously retrofitted, it must be fitted in the radio installation bay (
Page 2 - Figure 1
Insert and engage the plug connector -2- of the wiring harness into the LogBox -1-.
Use an appropriate cleaner (z. B. white spirit or isopropyl alcohol/isopropanol) to degrease the carrier of the dash
panel.
Secure the LogBox to the side of the carrier of the dash panel using self-adhesive hook and loop fastener tape as
shown.
10
1 x Installation instructions
◆
1 x Operating instructions "App for LogBox"
◆
1.2b). It is connected on the data bus diagnostic interface
1.2c).
1.2b).
1.2b).
5GV 051 629
5GV 051 629 A
1)
1.2a). Alternatively,
1.2b). The wiring harness is