Installation Process - Volkswagen 2K5 054 630 Manual De Montaje

Assembly Instructions
Genuine Parking Distance Warning System, Volkswagen Caddy 2015➤
Scope of delivery:
1 x Sensor holder RL
◆
1 x Sensor holder RR
◆
1 x Sensor holder RLC
◆
1 x Sensor holder RRC
◆
4 x Seal (isolating ring)
◆
4 x Sensor
◆
4 x Cover cap
◆
Required special tools, testing and measuring equipment and auxiliary equipment:
Assembly tool for PDC holder -VAS 6614 C-
◆
Wiring harness repair kit -VAS 1978-
◆

Installation process:

Note
The Genuine parking aid should be fitted by an authorised workshop. Incorrect installation may result in damage
◆
to the vehicle or the parking aid.
The Genuine parking aid is not suitable for fitting on vehicles which have subsequently been lowered (sport
◆
suspension, etc.).
The work to be performed on the vehicle, as described in these installation instructions, may vary in some
◆
circumstances as a result of model improvement measures. As such, changes to the wiring colours or even the
fitting locations cannot be discounted. In view of this, please ensure that you always use the appropriate current
circuit diagram or the current vehicle workshop manual.
Only the original German version is definitive. No liability is assumed for translation errors. Subject to technical modifications.
◆
1.1 Painting the sensors
Note
Do not clean the sensors with a silicone remover prior to painting but use a mild alcohol (isopropyl) instead.
◆
Additional general information concerning painting:
◆

Self-study programme No. 214/215
 Tape off the sensors so that only the visible outside surface of the sensors remains free.
 Paint the outside surface of the sensors the same colour as the car, applying the paint evenly and not too thickly.
 Repaint as necessary after drying, e.g. clear varnish for twin coat painting.
1.2 Installation of sensors and bumper wiring harness
Installation overview:
Page 2 - Figure 1
Note
In the figure, part of the vehicle bodywork is also shown (bottom right, wiring grommet area).
1 - Bumper cover
2 - Wiring grommet
3 - Sensor holder rear right (RR), with sensor, seal and cover cap
Sensor holder 2K5.919.492
◆
Sensor 5Q0.919.275
◆
Seal 5Q0.919.133
◆
Cover cap 2K5.971.883
◆
4 - Sensor holder rear right centre (RRC), with sensor, seal and cover cap
Sensor holder 2K5.919.492.A
◆
Sensor 5Q0.919.275
◆
Seal 5Q0.919.133
◆
Cover cap 2K5.971.883
◆
1 x Control unit
◆
1 x Buzzer (tone generator)
◆
1 x Bumper wiring harness
◆
1 x Retrofit wiring harness
◆
1 x Mounting material
◆
1 x Installation instructions
◆
Cleaning solution D 009 401 04
◆
Vehicle diagnostics tester with ODIS Service
◆
2K5 054 630
13