Assembling The Power Tool; Mounting The Loop Handle And Barrier Bar - Stihl KMA 130 R Manual De Instrucciones

13 Assembling the Power Tool

If one LED glows red continuously: the battery is
either too hot or too cold. Allow the battery to
warm up or cool down gradually at an ambient
temperature of about 50 °F to 68 °F (10 °C to
20 °C).
If all 4 LEDs flash red: the battery has a
malfunction and must be replaced. Do not
attempt to charge, use or store the battery.
12.2.2 Power Tool Status
The same LEDs on the battery will indicate the status of the
power tool.
If three LEDs glow red continuously: the power tool motor is
too hot. Allow the motor to cool down.
If three LEDs flash red when you activate the trigger switch:
the power tool has an electrical malfunction. Do not operate
the power tool. Have it checked by an authorized STIHL
servicing dealer before use or storage.
For troubleshooting information, @ 24.
12.2.3 Charge Status
The LEDs on the battery also show the battery's state of
charge.
To determine the battery's state of charge:
1
0458-805-8621-A
► Press the button (1) on the battery.
The LEDs on the battery will glow or flash green for about
5 seconds and indicate the state of charge (see
illustration).
For example:
If four green LEDs glow continuously: full charge.
If one green LED is flashing: less than 20 % charge.
13 Assembling the Power Tool

13.1 Mounting the Loop Handle and Barrier Bar

WARNING
To reduce the risk of injury from loss of control, ensure that
the loop handle and barrier bar are properly and securely
mounted before starting work.
To mount the loop handle and barrier bar:
► Switch off the power tool, @ 16.2.
► Remove the connecting cord, @ 15.2.
1
80-100%
60-80%
40-60%
20-40%
0-20%
► Insert the square nuts (2) in the barrier bar (1) and line up
the holes.
► Position one clamp (5) in the loop handle (3).
► Position the other clamp (7) against the underside of the
drive tube and line up the holes in the loop handle and
clamps.
3
2
5
6
7
8
English
4
25