Mounting The Loop Handle - Stihl KM 56 R Manual De Instrucciones

Mounting the Loop Handle

The loop handle comes in two different
versions.
Version A
A factory-new machine comes with the
loop handle already mounted.
Using the Barrier Bar
The barrier bar comes standard with the
machine and must be mounted to the
loop handle.
KM 56 R, KM 56 RC
Mounting the Barrier Bar
1
3
Fit the washer (1) on the M5x23
N
screw (2).
Hold the barrier bar (3) against the
N
loop handle and insert the screw
with washer.
Tighten down the screw (2) firmly.
N
Leave the barrier bar permanently
mounted to the loop handle.
Line up the loop handle.
0.2 in
(5,3 mm)
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Loosen the screw on the handle.
N
2
Slide the handle to the required
N
position.
Tighten down the screw so that the
N
handle cannot be rotated on the
drive tube.
Version B
A factory-new machine comes with the
loop handle already mounted.
English
A
13