Safety Precautions - SATA AE5811 Manual Del Uso

Compresor de aire de tipo husillo
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 192
中文
EN
DE
RU
KO
PT
JA
ES
AE5811/AE5812/AE5813

Safety precautions

1.The compressor unit shall be operated by a designated operator. The operator shall read, understand this manual and follow the work
procedures and safety precautions specified in it.
2.New compressor must be adjusted by the adjustor designated or approved by our company.
3.It is necessary to remove the surrounding flammable materials and carefully prevent the welding spark from falling into the air
compressor while welding the pipes in order to avoid burning some parts of the air compressor and to ensure that the ground wire is
connected securely, otherwise the compressor head may be damaged.
4.For the power cord to the air compressor, safety devices such as the air switch and fuse must be installed. To ensure reliable and safe
operation of the electrical equipment, a suitable ground wire must be connected. The lightning arrester shall be installed if necessary.
5.When the compressor is initially started or when the power cord is changed, it is important to check whether the rotation direction of the
compressor unit is right to prevent the compressor from burning out due to reverse rotation direction of the compressor head.
6.The compressor cannot operate under the discharge pressure specified on the nameplate, otherwise it will cause downtime due to
overloaded motor or burning-out of compressor.
7.Compressed air and electricity can be dangerous, so make sure that the power has been switched off and that all compressed air
has been completely released from the air compressor system during overhaul or maintenance. No one shall face the air outlet of any
compressor system or pneumatic device. When power is cut off for overhaul, the power box shall be locked, and the maintenance sign and
the "Do not close the switch" sign shall be installed at the power supply to prevent others from closing the power switch.
9.Do not force the compressor to start in case of a compressor failure or insecurities. In this case, switch off the power and clearly indicate
what happens.
10.Before start-up, make sure that there is no one inside the compressor unit and close its doors. During overhaul, it is necessary to ensure
that no person, tool or other object is in contact with any movable part in the compressor before starting. Before starting the compressor,
the maintenance man around the unit shall be notified to stay away from it.
11.The parts of the compressor unit shall be cleaned with non-corrosive and safe cleaning agent instead of the flammable, explosive or
volatile cleaning agent.
12.Safety valves, pressure switches and safety shutdown system must be checked regularly to ensure they are sensitive and reliable.
Usually, the compressor shall be checked once a year.
13.There shall be suitable fire extinguishers near the compressor unit.
14.If the air compressor is installed and used in a cold area, please start and run it without load for five minutes. When it has been warmed
up, run it with load. Otherwise, overcurrent may occur due to high viscosity of the lubricating oil.
15.If a new air compressor has been idle for more than one month after being adjusted or serviced, please fill the screw oil from the intake
valve and turn the pulley before re-starting. After start-up, run the compressor without load for five minutes to let the lubricating oil fully
work at the proper temperature.
16.If you have any questions about the screw air compressor from our company, please contact our technical department.
29

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ae5812Ae5813

Tabla de contenido