Settings; Cleaning; Changing The Power Line Fuse - Mettler Toledo LV11 Istrucciones De Manejo

4.3 Settings

ST5
ST6
110V
220V
E-Prom

4.4 Cleaning

Clean the housing regularly with a damp, soft cloth. Never use any corrosive solvents.
The feeder plate is made of stainless chrome steel and can be removed for cleaning as follows:
− Disconnect power plug
− Push side walls together a short way and simultaneously lift off the plastic cover.
− Detach feeder plate by jerking counter clockwise.

4.5 Changing the power line fuse

The fuse is located in the power switch combination.
For 230 V 160 L, 250 V
For 110V 315 L, 250 V
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The LV11 basically recognizes 16 intensity values (0 to 15), which are
assigned to the vibration levels (1 to 4). This assignment can be set through the
switch setting of the DIP switches (S4/1 and S4/2) on the printed circuit.
Vibration level
S4/1 S4/2 1 2
0 0 1 4
1 0 0 2
0 1 9 11 13 14
1 1 2 5
RS-232 interface
S4/3 RS protocol
0 Hardware handshake DTR/DSR on
1 Software Handshake Xon/Xoff on
S4/4 Interface parameters
0 2400 baud even parity
1 9600 baud no parity
METTLER TOLEDO LV11
3 4 Discharge
8 13 15 Factory setting
4 6 10 Small parts
15 Large parts
7 10 12 Midsize parts
Factory setting
7 bits
8 bits Factory setting
9