Safety; General Safety Information; Intended Use; Technical Limit Values - ABB TTR200 Instrucciones Para La Puesta En Funcionamiento

Pos: 3.1 /Überschriften/1/S - U/Sicherheit @ 0\mod_1129703894050_3101.doc @ 3168
1

Safety

Pos: 3.2 /Sicherheit/Allgemein/Allgemeines zur Sicherheit @ 0\mod_1129703939516_3101.doc @ 3260
1.1

General Safety Information

The "Safety" chapter provides an overview of the safety aspects to be observed for the
operation of the device.
The device is built based on state-of-the-art technology and is operationally safe. It was tested
and left the factory in a proper state. The requirements in the manual as well as the
documentation and certificates must be observed and followed in order to maintain this state for
the period of operation.
The general safety requirements must be complied with completely during operation of the
device. In addition to the general information, the individual chapters of the manual contain
descriptions about processes or procedural instructions with specific safety information.
Only the observance of all safety information enables the optimal protection of personnel as well
as the environment from hazards and the safe and trouble-free operation of the device.
Pos: 3.3 /Sicherheit/Temperatur/Allgemein/Bestimmungsgemäße Verwendung (Temperatur, Messumformer) @ 8\mod_1173276365022_3101.doc @ 71437
1.2

Intended use

This device is intended for the following uses:
• To measure the temperature of fluid, pulpy or pasty substances and gases or
resistance/voltage values.
The following items are included in the intended use:
• Read and follow the instructions in this manual.
• Observe the technical ratings (refer to the section "Technical data" or data sheet).
Pos: 3.4 /Sicherheit/Allgemein/Hinweis zur bestimmungswidrigren Verwendung (Wartung/Reparatur) @ 0\mod_1129707002440_3101.doc @ 3240
Repairs, alterations and enhancements or the installation of replacement parts is only
permissible as far as described in the manual. Further actions must be verified with ABB
Automation Products GmbH. Excluded from this are repairs performed by ABB-authorized
specialist shops.
Pos: 3.5 /Sicherheit/Temperatur/TTR/Technische Grenzwerte (Temperatur) CI @ 18\mod_1204809223618_3101.doc @ 167566
1.3

Technical limit values

The device is designed for use exclusively within the stated values on the name plate and in the
technical specifications (see data sheets). These must be complied with accordingly, e.g.:
• The maximum operating temperature may not be exceeded.
• The permitted operating temperature may not be exceeded.
• The housing protection system must be observed.
Pos: 3.6 /======= Seitenumbruch ======== @ 0\mod_1126532365768_3101.doc @ 3830
CI/TTR200-X1 TTR200
Safety
EN - 3