Installation And Connection; Installing The Btl - Balluff BTL7-A/C/E5 Serie Manual De Instrucciones

BTL7-A/C/E5 _ _ -M _ _ _ _ -SF-F _ _
Magnetostrictive Linear Position Sensor – Rod Style
4

Installation and connection

4.1

Installing the BTL

For holding the BTL and float we recommend non-
magnetizable material.
Installing the float
1. Install the float (accessory) taking the orientation into
account (raised markings on top, see Fig. 4-1 and
Fig. 4-2).
2. Secure the float using the cotter pin (included in the
scope of delivery of the float), without placing any
mechanical loads on the rod. Guide the cotter pin
through the hole until it engages (see Fig. 4-3).
8 english
Fig. 4-1: Installing the float
Fig. 4-2: Raised markings on float
Fig. 4-3: Inserting the cotter pin