Approved Media; Target Groups And Qualifications; Safety Instructions For Transport - ABB CoriolisMaster FCM2000 Instrucciones Para La Puesta En Funcionamiento

Pos: 3.12 /Standard-Layout/Sicherheit/Durchfluss/FCM2000/Zulässige Messstoffe FV4000 und FCM2000 @ 25\mod_1233838427718_3101.doc @ 243363 @ 2 @ 1
1.5

Approved media

When using media, please note:
• Media (fluids) may only be used if, based on the state of the art or the operating experience
of the user, it can be assured that chemical and physical properties of the components
coming into contact with the fluids will not be adversely affected during the operating period.
• Specifically chloride media can cause not visible corrosion damages to all media wetted
components so that fluid can lead. The suitability of these materials for each application by
the operator to examine.
• Media (fluids) with unknown properties or abrasive media may only be used if the operator
can perform regular and suitable tests to ensure the safe condition of the meter.
• Observe the information on the name plate.
Pos: 3.13 /Standard-Layout/Überschriften/1.1/1-spaltig/V - Z/Zielgruppen und Qualifikationen @ 22\mod_1222689902850_3101.doc @ 219227 @ 2 @ 1
1.6

Target groups and qualifications

Pos: 3.14 /Standard-Layout/Sicherheit/Allgemein/Zielgruppen und Qualifikationen @ 22\mod_1222689951319_3101.doc @ 219251 @ @ 1
Installation, commissioning, and maintenance of the product may only be performed by trained
specialist personnel who have been authorized by the plant operator to do so. The specialist
personnel must have read and understood the manual and comply with its instructions.
Prior to using corrosive and abrasive materials for measurement purposes, the operator must
check the level of resistance of all parts coming into contact with the materials to be measured.
ABB Automation Products GmbH will gladly support you in selecting the materials, but cannot
accept any liability in doing so.
The operators must strictly observe the applicable national regulations with regards to
installation, function tests, repairs, and maintenance of electrical products.
Pos: 3.15 /Standard-Layout/Sicherheit/Durchfluss/FCM2000/Sicherheitshinweise zum Transport (Durchfluss) @ 7\mod_1174894735718_3101.doc @ 74253 @ 2 @ 1
1.7

Safety instructions for transport

Observe the following instructions:
• The center of gravity is off center.
• The flow direction must correspond to the direction indicated on the device, if labeled.
• Comply with the maximum torque for all flange connections.
• Install the devices without mechanical tension (torsion, bending).
• Install flange devices with coplanar counter flanges.
• Only install devices for the intended operating conditions and with suitable seals.
• Secure the flange bolts and nuts against pipeline vibrations.
Pos: 3.16 /Standard-Layout/======= Seitenumbruch ======== @ 0\mod_1126532365768_3101.doc @ 3830 @ @ 1
CI/FCM2000-EN CoriolisMaster FCM2000
Safety
EN - 5