Final Installation - Harbor Breeze RLC52WW5C1R Manual Del Usuario

WIRING
2.
Wrap electrical tape (not included) around each
individual wire connector (BB) down to the wire.
WARNING: Make sure no bare wire or wire
strands are visible after making connections. Place
GREEN and WHITE wire connections on the
opposite side of the outlet box as the BLACK wire
connections.
Turn spliced/taped wires upward and gently push
wires and wire connectors (BB) into outlet box.
Hardware Used
BB
E3 Wire Connector

FINAL INSTALLATION

1. Leave hook end of motor assembly (E) in square
opening of mounting bracket (A) and lift the other end
of motor assembly (E) toward mounting bracket (A).
Align motor assembly (E) screw holes with mounting
bracket (A) screw holes and re-insert motor mounting
screws (R) and motor mounting washers (S)
previously removed (Step 5, page 7). Securely
tighten all motor mounting screws (R) with Phillips
screwdriver (not included).
WARNING: It is extremely important to tighten
motor mounting screws (R) completely so motor
assembly (E) is mounted securely.
2. Partially loosen the motor housing screws (B)
installed with the motor housing lock washers (C);
remove the motor housing screws (B) installed with
the motor housing star washers (D).
Raise motor housing (F) to mounting bracket (A)
allowing slotted holes in motor housing (F) to align
with loosened motor housing screws (B). Twist motor
housing (F) to lock in place. Re-install the motor
housing screws (B) and motor housing star washers
(D) that were removed and then tighten all motor
housing screws (B) to secure motor housing (F).
2
BB
x 3
1
A
S
R
3 2
C
B
D
Lowes.com/harborbreeze
8
BB
BB
S
R
E
A
C
B
F
D
Slotted
Hole