Metabo HPT C 12FDHB Instrucciones De Seguridad Y Manual De Instrucciones página 13

3. Releasing the locking pin
Locking pin
Pull
Fig. 5
4. Installing the sub fence (L), dust bag, extension holder, stopper and vises
(The extension holder and stopper are optional accessories.)
Attach the sub fence (L), dust bag and vise assembly as indicated in Fig. 1 and Fig. 2.
Dust bag
Duct
Fig. 6
CAUTION:
WARNING:
(Attach the vise assembly as shown in Fig. 1, Fig. 2 and Fig. 18.)
Handle
Install the dust bag onto the duct on the miter saw. Fit the
supprot bar of the dust bag and the duct together.
To empty the dust bag, pull out the dust bag assembly
from the duct. Open zipper on underside of bag and empty
into waste container. Check frequently and empty the
dust bag before it gets full.
Empty the dust bag frequently to prevent the duct and the lower
guard from becoming clogged.
Sawdust will accumulate more quickly than normal during bevel
cutting.
Do not use this saw to cut and/or sand metals. The hot chips or
sparks may ignite saw dust from the bag material.
When the power tool is prepared for shipping, its
main parts are secured by a locking pin.
Move the handle slightly so that the locking pin
can be disengaged.
NOTE:
Lowering the handle slightly will
enable you to disengage the locking
pin more easily and safely.
The lock position of the locking pin is
for carrying and storage only.
English
13