Metabo HPT C 12FDHB Instrucciones De Seguridad Y Manual De Instrucciones página 19

6. Confi rmation for use of sub fence (L) (Fig. 12-b)
WARNING:
6 mm screw
8 mm knob bolt
Fence (L)
Fig. 12-b
7. Bevel angle 33.9°, 45°, 48°
Located deep within both sides of the base are angle block (A) and angle block (B). These
angle blocks are required when sitting up the right and left bevel angles of 33.9°, 45°, or 48°
on the right and left.
(1) Bevel angle of 33.9° (right and left) (Fig. 13-a)
Set up with angle block (A) and angle block (B) stacked, and rotate from B to direction
A. After pulling out the sub fence, loosen the bevel lock handle and tilt the motor head
to place either the 6 mm hex socket screw (A) (when tilted to the left) or the 6 mm hex
socket screw (B) (when tilted to the right) on angle block (B). When the bevel angle is
set, tighten the bevel lock handle to secure the motor head.
(2) Bevel angle of 45° (right and left) (Fig. 13-b)
Rotate angle block (B) on its own from A to direction B. Set angle block (A) on side A.
After pulling out the sub fence, loosen the bevel lock handle and tilt the motor head to
place either the 6 mm hex socket screw (A) (when tilted to the left) or the 6 mm hex
socket screw (B) (when tilted to the right) on angle block (A). When the bevel angle is
set, tighten the bevel lock handle to secure the motor head.
When left bevel angle cutting, loosen the 8 mm knob bolt, then
slide the sub fence (L) outward.
Failure to do so may result in the main body or saw blade coming
into contact with the sub fence (L) and causing injury.
Sub fence (L)
This power tool is equipped with a sub fence (L).
In the case of direct angle cutting and right
bevel angle cutting, use the sub fence (L).
Then, you can realize stable cutting of the
material with a wide back face.
When left bevel angle cutting, loosen the 8 mm
knob bolt, then slide the sub fence (L) outward,
as shown in Fig. 12-b.
If unable to get enough clearance with the
motor head because the bevel angle is too
large, loosen the 6 mm screw and remove the
sub fence (L).
NOTE:
When transporting the saw, always
secure the sub fence (L) in the
collapsed position and lock it.
English
19