Metabo HPT C 12FDHB Instrucciones De Seguridad Y Manual De Instrucciones página 18

English
4. Stopper for precision cutting ... (Stopper and holder are optional accessory)
Workpiece
6 mm wing bolt
(Optional accessory)
5. Confi rmation for use of sub fence (R) (Fig. 12-a)
WARNING:
8 mm knob bolt
Fence (R)
Fig. 12-a
18
Stopper
(Optional accessory)
Holder
(Optional accessory)
Height adjustment bolt 6 mm
(Optional accessory)
Fig. 11
When right bevel angle cutting, loosen the 8 mm knob bolt, then
slide the sub fence (R) outward.
Failure to do so may result in the main body or saw blade coming
into contact with the sub fence (R) and causing injury.
6 mm screw
Sub fence (R)
The stopper facilitates continuous precision
cutting in lengths of 11-27/64" to 18" (290 mm
to 460 mm).
To install the stopper, attach it to the holder
with the 6 mm wing bolt as shown in Fig. 11.
6 mm
wing nut
(Optional
accessory)
This power tool is equipped with a sub fence
(R).
In the case of direct angle cutting and left bevel
angle cutting, use the sub fence (R). Then, you
can realize stable cutting of the material with a
wide back face.
When right bevel angle cutting, loosen the 8 mm
knob bolt, then slide sub fence (R) outward, as
shown in Fig. 12-a.
If unable to get enough clearance with the
motor head because the bevel angle is too
large, loosen the 6 mm screw and remove the
sub fence (R).
NOTE:
When transporting the saw, always
secure the sub fence (R) in the
collapsed position and lock it.