Metabo HPT C 12FDHB Instrucciones De Seguridad Y Manual De Instrucciones página 24

English
3. Cutting Operation
Adjusting line
(Front view)
Workpiece
ⓐ
Marking ⓐ
(pre-marked)
(Front view)
Fig. 20
CAUTION:
WARNING:
24
Saw blade
ⓑ
Saw blade
ⓑ
Marking
(pre-marked)
Increased pressure on the handle will not increase the cutting
speed.
On the contrary, too much pressure may result in overload of the
motor and/or decreased cutting effi ciency.
* Confi rm that the trigger switch is turned OFF and the power plug
has been removed from the receptacle whenever the tool is not
in use.
* Always turn the power off and let the saw blade stop completely
before raising the handle from the workpiece.
If the handle is raised while the saw blade is still rotating, the cut-
off piece may become jammed against the saw blade causing
fragments to scatter about dangerously.
* Every time one cutting or deep-cutting operation is fi nished,
turn the trigger switch off , and check that the saw blade has
stopped. Then raise the handle, and return it to the full retract
position.
* Be absolutely sure to remove the cut material from the top of the
turntable, and then proceed to the next step.
* Continued cutting operation can result in overload of the motor.
Touch the motor assembly and if it's hot, stop your cutting
operation at once and rest for 10 minutes or so, and then restart
your cutting operation.
(1) As shown in Fig. 20 the width of the saw
blade is the width of the cut. Therefore,
slide the workpiece to the right (viewed
from the operator's position) when length
ⓑ is desired, or to the left when length ⓐ
is desired.
Turn the LED light, project the shadow of
the blade onto the workpiece, align the left
side or right side of shadow of the blade
with the ink line on the workpiece.
(2) Once the saw blade reaches maximum
speed, push the handle down carefully until
the saw blade approaches the workpiece.
(3) Once the saw blade contacts the workpiece,
push the handle down gradually to cut into
the workpiece.
(4) After cutting the workpiece to the desired
depth, turn the power tool OFF and let the
saw blade stop completely before raising
the handle from the workpiece to return it
to the full retract position.