Metabo HPT C 12FDHB Instrucciones De Seguridad Y Manual De Instrucciones página 27

The table below shows the miter angle and the bevel angle settings that are ideal for the two
crown molding types.
NOTE:
For convenience, positive stops are provided for the miter setting (left and
right 31.6°) positions.
For miter cut setting
If the turntable has been set to either of the angles described, move the turntable adjusting
miter lock handle a little to the right and left to stabilize the position and to properly align the
miter angle scale and the tip of the indicator before the operation starts.
For bevel cut setting
Move handle on bevel section to the left and check that the position is stable and that the
bevel angle scale and the tip of the indicator are properly aligned. Then tighten the bevel
lock handle.
To process crown molding at
positions
Type of Crown
Molding
Miter Angle
Setting
45° Type right 35.3°
38° Type right 31.6°
(1) Setting to cut crown moldings at positions
left):
Turn the turntable to the right and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
Tilt the motor head to the left and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
Position the crown molding so that the upper surface (Ⓐ in Fig. 23) contacts the fence
as indicated in Fig. 27.
(2) Setting to cut crown moldings at positions
left):
Turn the turntable to the left and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
Tilt the head to the left and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
Position the crown molding so that the lower surface (Ⓑ in Fig. 23) contacts the fence
as in Fig. 28.
and in Fig. 24.
Bevel Angle
Setting
left 30°
left 33.9°
and
35.3°
31.6°
30°
33.9°
and
35.3°
31.6°
30°
33.9°
To process crown molding at
positions and
Miter Angle
Setting
left 35.3°
left 31.6°
in Fig. 24 (see Fig. 25; tilt the head to the
in Fig. 24 (see Fig. 26; tilt the head to the
English
in Fig. 24.
Bevel Angle
Setting
left 30°
left 33.9°
27