Metabo HPT C 12FDHB Instrucciones De Seguridad Y Manual De Instrucciones página 25

4. Miter cutting procedures
Miter scale
Unlock
Miter lock
handle
Lock
Miter detent
Postive stop
override button
lock button
(4) If the desired miter angle is NOT one of the nine positive stops noted below, please see
the Miter detent override button section on page 21.
(5) Turn the LED light on and position the workpiece on the table for pre-alignment of your cut.
CAUTION:
NOTE:
* Positive stops are provided at the right and left of the 0° center setting,
at 15°, 22.5°, 31.6° and 45° settings.
Check that the miter scale and the tip of the indicator are properly
aligned.
* Operation of the saw with the miter scale and indicator out of alignment
will result in poor cutting precision.
5. Bevel cutting procedures
Set button
Bevel scale
Indicator
(for right bevel
scale)
Bevel scale
(4) By using angle block (A) and angle block (B), you can easily set up bevel angles of 33.9°, 45°,
or 48°. For details, see the "Bevel angle 33.9°, 45°, 48°" section on page 19.
Indicator
Turntable
Fig. 21
Always check that the miter lock handle is secured and the
turntable is clamped.
If you attempt angle cutting without clamping the turntable, then
the turntable might shift unexpectedly causing injuries.
Bevel lock handle
Loosen
Tighten
Indicator
(for left bevel scale)
Fig. 22
(1) Unlock the turntable by lifting up on the miter
lock handle.
(2) While pressing down on the positive stop lock
button, grasp the miter lock handle and rotate
the turntable left or right to the desired angle.
(3) Once the desired miter angle is achieved,
release the positive stop lock button and press
down on the miter lock handle to secure the
turntable into position.
(1) Loosen the bevel lock handle and bevel
the saw blade to the left or to the right.
When tilting the motor head to the right,
Pull
push the set button.
(2) Adjust the bevel angle to the desired
setting while watching the bevel angle
scale and indicator, then secure the bevel
lock handle. When contacting the work
bench and the main body, pull the bevel
lock handle in the direction of the arrow
mark as illustrated in Fig. 22, and change
the direction of the bevel lock handle.
(3) Turn the LED light on and position the
workpiece on the table for pre-alignment
of your cut.
English
25