Metabo HPT C 12FDHB Instrucciones De Seguridad Y Manual De Instrucciones página 26

English
NOTE:
* Positive stop are provided at right and left of the 0° center setting, at
33.9° and 45° settings.
Check that the bevel scale and the tip of the indicator are properly
aligned.
WARNING:
CAUTION:
6. Compound cutting procedures
Compound cutting can be performed by following the instructions in 4 and 5 above. For
maximum dimensions for compound cutting, refer to "SPECIFICATIONS" table on page 10.
CAUTION:
7. Crown molding cutting procedures
Fig. 23 shows two common crown molding types having angles of (θ) 38° and 45°.
For the typical crown molding fi ttings, see Fig. 24.
Ⓐ
Upper surface
ceiling
Ⓑ
Lower surface
Wall
26
* When the workpiece is secured on the left or right side of the
blade, the short cut-off portion will come to rest on the right or
left side of the saw blade. Always turn the power off and let the
saw blade stop completely before raising the handle from the
workpiece.
If the handle is raised while the saw blade is still rotating,
the cut-off piece may become jammed against the saw blade
causing fragments to scatter about dangerously.
* When stopping the bevel cutting operation halfway, start cutting
after pulling back the motor head to the initial position.
Starting from halfway, without pulling back, causes the lower
guard to be caught in the cutting groove of the workpiece and
to contact the saw blade.
Always check that the clamp lever is secured and the motor head
is clamped. If you attempt bevel angle cutting without clamping
the motor head, then the motor head might shift unexpectedly
causing injuries.
Always secure the workpiece with the right hand side for compound
cutting (bevel saw blade to left) or secure the workpiece with left
hand side for compound cutting (bevel saw blade to right), because
the saw blade might the contact the clamp or vise that secures the
workpiece, and cause personal injury or damage.
Fig. 23
Ceiling
Wall
Inside corner Outside corner
Fig. 24