Zapf Creation BABY born interactive ethnic Manual Del Usuario página 4

Bei unsachgemäßer Entsorgung können gefährliche Stoffe aus Elektro- und Elektronikgeraten in die Umwelt
gelangen.
Dear parents,
Congratulations on your purchase of a Zapf Creation AG product. Before using the product for the first time, we
recommend you carefully read the instruction manual and keep it stored with the packaging in case you might
need it later.
All about batteries/rechargeable batteries:
• Use alkaline batteries for best performance and longer life.
• Use only the battery type recommended for the unit.
• Batteries must only be replaced by an adult.
• Insert batteries with the correct polarity (+ and -).
• Do not mix different types of batteries or old and new batteries.
• The supply terminals are not to be short-circuited.
• Do not mix rechargeable and non-rechargeable batteries.
• Do not recharge non-rechargeable batteries.
• Rechargeable batteries are to be removed from the toy before charging.
• Rechargeable batteries are to be recharged only under adult supervision.
• When the product is not used for an extended time, switch button to "OFF" position for longer battery life
time. We also recommend removing batteries to prevent possible leakage and damage to the unit.
• If moisture gets into the battery compartment, dry with a cloth.
• Exhausted batteries are to be removed from the toy and taken to special waste collection point.
Preparation
Included Batteries are only intended to use for demonstration at retail. If necessary, please exchange the batteries
before using the product for the first time. Insertion of batteries should be done by an adult as follows:
1. Set the switch on the battery compartment to "OFF". (Fig.1)
2. Use a screwdriver to open the battery compartment. (Fig.1)
3. Insert the 3x 1.5V AA (LR6) batteries. Please check if the polarity is correct. (Fig.2)
4. Screw the cover of the battery compartment back on again. (Fig.1)
5. Set the switch on the battery compartment to "ON". (Fig.1)
Please ensure that no water penetrates the electronics of the battery compartment, i.e. always make sure that the
battery compartment is securely and tightly closed before giving the product to your child to play with.
Functional steps :
1. Switch "ON" - a BABY born® song sounds
2. Insert Map 1 - a " pling " sound is heard - If the wrong card is inserted you will hear a high-pitched humming
sound.
3. On the card the light for the scanner will start flashing.
With the scanner please scan the doll from the bottom to the top.
To activate, press the scanner with the front edge on the doll evenly and then scan along the complete
BABY born® - a corresponding sound can be heard for about 8 seconds and the lights flash alternately on
the map.
When scanning is completed, a flashing light on the right side will indicate which card must be used next
(map 2 or 3).
Alternatively a happy face lights up and a laugh is heard, then BABY born ®'s health check is completed.
4. If BABY born® is healthy, no other map needs to be inserted.
To continue playing repeat step 3.
5. However if in Step 3 BABY born does need further investigation insert map 2 or 3 to continue play.
6. After the appropriate card is inserted, you will hear a " pling " sound. ( If you insert the wrong card you will
hear a high-pitched humming sound.)
The scanner flashes and is ready for the next scan .
For this press the scanner at the top half of the BABY born® (for map 2)
or the bottom half of the BABY born® (for map 3) once and scan over each area .
As long as the scanning sound is heard, the lights will flash on the map.
After scanning the display area will light up the area to be treated and a noise can be heard.
GB
4