Descargar Imprimir esta página

BWT AQA drink WD CO2 Instrucciones De Montaje Y Manejo página 7

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10
4. SAFETY INSTRUCTIONS FOR CO
Caution!
Observe the manufacturer's warnings and transportation and storage regulations.
Protect gas cylinders from excessive heat, mechanical damage and corrosive substances.
Do not connect or store gas cylinders in zones with an increased fire hazard.
Place gas cylinders at a distance of at least 0.5 m from radiators.
Place gas cylinders so that they are easily accessible.
EN
Place gas cylinders away from emergency exits and escape routes.
Store full and empty gas cylinders separately and according to the type of gas.
Gas cylinders may only be stored and transported when the covering cap is screwed on.
Gas cylinders must be stored upright and secured against falling over.
Only connect gas cylinders with pressure reducers and safety valves.
In the event of leaks or fire: close the cylinder valves immediately. Cool heated cylinders with water.
In workshops and laboratories, set up only as many reserve cylinders as you need for continuous
operation.
Do not oil or grease cylinder valves.
Close the cylinder valves when the unit is to be decommissioned or when the gas cylinders are
empty.
12
CYLINDERS
2
5. IMPORTANT NOTICE
Notice!
Always keep the fitting and operating instructions close at hand to avoid any mistakes and before
carrying out any work on the device you should read the fitting and operating instructions carefully
and follow them. While our data sheets and brochures should provide advice to the best of our
knowledge, the content thereof is not legally binding. In addition to this, our general terms and
conditions of trade apply. Subject to alterations!
EN
13

Publicidad

loading