Bosch BSA 42 Serie Instrucciones De Funcionamiento página 23

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 46
Step
3. Select measurement mode:
$
Axle measuring.
$
Left single wheel measurement.
$
Right single wheel measurement.
$
Left 4WD single wheel measure-
ment.
i
4WD single wheel measurements
are only possible with the remote
control unit.
$
Right 4WD single wheel measure-
ment.
i
4WD single wheel measurements
are only possible with the remote
control unit.
4. Measure out-of-roundness (optional):
Press brake pedal and hold steady at a
braking force greater than 500 N.
Press out-of-roundness button.
i
This measurement is only possible
with the remote control unit.
5. Measure braking forces:
Slowly and steadily depress brake
pedal until maximum braking force
(slip) is attained.
Release brake pedal again.
i
Shut-off criteria:
$
Wheel lock-up (slip monitoring).
$
Vehicle out of position (slip rollers
no longer pressed).
$
Maximum braking force (slip) not at-
tained on braking and braking action
remains at rolling resistance level for
more than six seconds.
6. End measurement
Start "Axle measuring" measurement
mode
Drive vehicle off set of rollers.
Robert Bosch GmbH
Manual mode (normal operation) | BS� ���� | ��
�nalog display
Remote
control unit
1 second
2 x 1 second
3 x 1 second
+
+
Out-of-roundness
button
1 second
BS� ���� | ��
Result / �nalog display
? Announcement phase:
$
Warning lamp flashes.
$
The dynamometer motors start
up, the test rollers turn.
$
The rolling resistance is measured.
"
Ready for braking force measure-
ment.
i
The measurement can be terminated
at any time with the Automatic
button or the STOP button.
? The out-of-roundness of the brakes
is measured for 5 seconds.
? The LCD indicates the measurement
result.
"
Out-of-roundness measurement is
over.
? Peak values are displayed
(for approx. 5 seconds)
$
Pointer: Maximum braking force
on left and right.
$
LCD: Value displayed depends
on display option set. Refer to
Section 5.3.6.
"
The measured values can now be
stored. Refer to Section 5.3.2.
"
Braking force measurement is over.
1 691 506 010
| ��
en
|
2009-05-25

Publicidad

Tabla de contenido
loading

Tabla de contenido