Serpento COBRA Manual De Usuario página 112

46
Replacement of Bulbs
Each bulb's power is shown below. When changing the bad bulb, the one with the same value must be used. Otherwise it may cause overload
of the electric circuit system and early damage to the bulbs.
Headlamp
Tail/Stop lamp
Turning signal lamp
Headlamp
1.Remove two screws outside the headlamp and pull out the lamp assembly.
2.Pull apart the bulb holder by rotating it anti-clockwise.
3.Pull apart the bulb by rotating it anti-clockwise.
4.Install a new bulb and replace the assembly.
12V 35W/35W
12V 5W/21W
12V 10W