Data Memory; Viewing The Stored Values; Memory Full; Clearing All Values - Microlife BP A7 Touch BT Manual Del Usuario

5. Data Memory

This device automatically stores up to 99 measurement values for
each of the 2 users and guest mode.

Viewing the stored values

Switch the lock switch 3 to «unlock» position. Select either user
1 or 2 with the user indicator BM. Press the M-button AO briefly. The
display shows an average value.
Pressing the M-button again displays the previous value. Pressing
the M-button repeatedly enables you to move from one stored
value to another.

Memory full


Pay attention that the maximum memory capacity of 99
memories per user is not exceeded. When the 99 memory is
full, the oldest value is automatically overwritten with the
100th value. Values should be evaluated by a doctor before
the memory capacity is reached – otherwise data will be lost.

Clearing all values

Make sure the correct user is activated.
1. Firstly unlock the device 3, then select either 1 or 2 with the
user indicator BM.
2. Hold down the M-button AO until «CL» appears and then release
the button.
3. Press the M-button while «CL» is flashing to permanently clear
all values of the selected user.

Cancel deletion: press START/STOP button AN while «CL»
is flashing.

Individual values cannot be cleared.

6. Battery Indicator and Battery change

Low battery

When the batteries are approximately ¾ empty the battery symbol AS
will flash as soon as the device is switched on (partly filled battery
displayed). Although the device will continue to measure reliably, you
should obtain replacement batteries.
Flat battery – replacement
When the batteries are flat, the battery symbol AS will flash as soon
as the device is switched on (flat battery displayed). You cannot
take any further measurements and must replace the batteries.
1. Open the battery compartment AT at the back of the device.
2. Replace the batteries – ensure correct polarity as shown by the
symbols in the compartment.
BP A7 Touch BT
3. To set date and time, follow the procedure described in
«Section 2.».

The memory retains all values although date and time must
be reset – the year number therefore flashes automatically
after the batteries are replaced.

Which batteries and which procedure?


Use 4 new, long-life 1.5 V, size AAA alkaline batteries.

Do not use batteries beyond their date of expiry.

Remove batteries if the device is not going to be used for a
prolonged period.

Using rechargeable batteries

You can also operate this device using rechargeable batteries.

Only use «NiMH» type reusable batteries.

Batteries must be removed and recharged when the flat
battery symbol appears. They should not remain inside the
device as they may become damaged (total discharge as a
result of low use of the device, even when switched off).

Always remove the rechargeable batteries if you do not
intend to use the device for a week or more.

Batteries cannot be charged in the blood pressure monitor.
Recharge batteries in an external charger and observe the
information regarding charging, care and durability.

7. Using a Mains Adapter

You can operate this device using the Microlife mains adapter
(DC 6V, 600 mA).

Only use the Microlife mains adapter available as an original
accessory appropriate for your supply voltage.

Ensure that neither the mains adapter nor the cable are
damaged.
1. Plug the adapter cable into the mains adapter socket 9 in the
blood pressure monitor.
2. Plug the adapter plug into the wall socket.
When the mains adapter is connected, no battery current is consumed.
®
8. Bluetooth Function
This device can be used in conjunction with a smartphone running
the «Microlife Connected Health+» App. The Bluetooth
tion is automatically active after the measurement has been
completed.
®
connec-
EN
5