Pit Boss 3 Serie Montaje Y Operación página 20

"Er1" Error Code Temperature Probe
Wire Not Making
Connection
"noP" Error Code Bad Connection At
Connection Port
Meat Probe Damaged Check for signs of damage to the wires of the meat probe. If damaged, call Customer Service
Faulty Control Board
Thermometer Smoker Has High
Shows Temperature Ambient Temperature
When Unit Off Or Is In Direct Sun
Smoker Will Insufficient Air Flow
Not Achieve Or Through Burn Pot
Maintain Stable
Temperature
Lack Of Fuel, Poor Fuel
Quality, Obstruction In
Feed System
Temperature Probe
Smoker Produces Grease Build-Up
Excess Or
Wood Pellet Quality
Discolored Smoke
Burn Pot Is Blocked
Insufficient Air Intake
For Fan
Frequent Flare-Ups Cooking Temperature
Grease Build-Up On
Cooking Components
20
Access the electrical components on the base of the unit (see Electric Wire Diagram ) and
check for any damage to the Temperature Probe wires. Ensure Temperature Probe spade
connectors are firmly connected, and connected correctly, to the Control Board.
Disconnect meat probe from connection port on the Control Board, and reconnect. Ensure the
meat probe adapter is firmly connected. Check for signs of damage to the adapter end. If still
failed, call Customer Service for replacement part.
for replacement part.
Control Board needs to be replaced. Contact Customer Service for a replacement part.
This will not harm the smoker. The internal temperature of the main cabinet has ambiently
reached or exceeded 54°C / 130°F. Move the smoker into a shaded area. Prop the cabinet door
open to reduce the internal temperature.
Check burn pot for ash build-up or obstructions. Follow Care and Maintenance instructions
for ash build-up. Check fan. Ensure it is working properly and air intake is not blocked. Follow
Care and Maintenance instructions if dirty. Check auger motor to confirm operation, and
ensure there is no blockage in the auger tube. Once all the above steps have been done,
start the smoker, set temperature to SMOKE and wait for 10 minutes. Check that the flame
produced is bright and vibrant.
Check hopper to check that fuel level is sufficient, and replenish if low. Should the quality of
wood pellets be poor, or the length of the pellets too long, this may cause an obstruction in
the feed system. Remove pellets and follow Care and Maintenance instructions.
Check status of temperature probe. Follow Care and Maintenance instructions if dirty.
Contact Customer Service for a replacement part if damaged.
Follow Care and Maintenance instructions.
Remove moist wood pellets from hopper. Follow Care and Maintenance instructions to
clean out. Replace with dry wood pellets.
Clear burn pot of moist wood pellets. Follow Hopper Priming Procedure.
Check fan. Ensure it is working properly and air intake is not blocked. Follow Care and
Maintenance instructions if dirty.
Attempt cooking at a lower temperature. Grease does have a flash point. Keep the temperature
under 176°C / 350°F when cooking highly greasy food.
Follow Care and Maintenance instructions.