The Control Board system is an intricate and valuable piece of technology. For protection from power surges and electrical shorts,
consult the wire diagram below to ensure your power source is sufficient for the operation of the unit.
PB – ELECTRIC REQUIREMENTS
220-240V, 50HZ, 250W, 3-PRONG GROUNDED PLUG
NOTE: Electrical components, passed by product safety testing and
certification services, comply with a testing tolerance of ± 5-10 percent.
DISCONNECT POWER
SUPPLY BEFORE SERVICE
OR MAINTENANCE.
FUEL INPUT
GROUNDED
POWER CORD
RATING:
H05RN-F 3G1.0MM2
1.1 KG/H
300V/500V AS/NZS
(2.4 LB/H)
BURN POT
INDEX
W : WHITE
Y : YELLOW
P : PURPLE
R : RED
K : BLACK
S : SILVER
ELECTRICAL WIRE DIAGRAM
REMOVE TWO GREASE
TRAY BRACKETS FROM
UNDERSIDE OF UNIT.
K
K
W
W
G
GROUND
W
P
W
W
W
W
IGNITER ASSEMBLY /
HD CARTRIDGE HEATER
200W, 230V,
0.375" X 5.0"/ 9.5 X 127MM
REMOVE WIRE COMPONENTS
HOUSING FROM UNDERSIDE
OF UNIT.
K
S
TEMPERATURE PROBE
MOLEX CONNECTORS
CONTROL BOARD
FAST-BLOW FUSE
P
Y
P
Y
R
W
W
R R
AUGER MOTOR
& FEED SYSTEM
230V, 50HZ, ,
2 RPM MOTOR
ACCESS WIRING COMPONENTS
LOCATED IN TEMPERATURE
PROBE HOUSING.
TEMPERATURE
PROBE
Y
Y
Y
DRAFT FAN
230V, 50HZ,
1 PHASE
21