Cleaning & Maintenance; Cleaning The Device - Apex iX Fit Manual De Instrucciones

iX Fit / English
5. Cleaning & Maintenance

5.1 Cleaning the Device

The device should be checked and dusted regularly (at least every 30 days).
1. Unplug the device.
2. Wipe the outside of the device with a cloth dampened with water and mild detergent (please
disconnect accessories if necessary. Please refer to 3.2.3 Disconnecting accessories –
Humidifier and Light grey tubing.)
3. Device should be air-dried thoroughly before use. Inspect the device and all circuit parts for any
damage after cleaning and replace if necessary.
WARNING: To avoid electrical shock, always unplug the power cord from the wall outlet
before cleaning the device.
WARNING: Don't try to open this device. Repairs and internal servicing should only be
performed by an authorized service agent. Do not drop any object into the air tubing or air
outlet.
WARNING: Please do not repair the device during operation.
5.2 Cleaning the Humidifier (and water chamber)
The humidifier should be checked and cleaned daily (or after every time use) to prevent the
growth of germs that might affect the user's health.
1. Disconnect accessories if necessary. (Please refer to 3.2.3 Disconnecting accessories –
Humidifier and Light grey tubing)
2. Wipe the outside of the humidifier with a cloth dampened with water and mild detergent.
3. Open the water chamber and discard any remaining water.
4. Soak and shake the component (top and bottom cover) in a tub or sink filled with warm water
(approximately 86°F/30°C) and mild liquid detergent (e.g. Prolystica® 2X Neutral Detergent 4
mL per L) for up to 10 minutes.
5. Whilst immersed in the solution, clean with a soft bristle brush for 2 minute. Brush inside and
outside of the component.
6. Rinse and shake vigorously in a tub or sink of clean water for Iminute.
7. Repeat for one more minute using fresh water.
8. Inspect to ensure the component is clean and detergent free. Wash and rinse again, if
necessary.
9. Leave the component to dry out of direct sunlight or heat before reassembling.Inspect all parts
for any damage after cleaning and replace if necessary.
17