Fein BLK1.3TE Manual Original página 19

Original Instruction Manual for Nibbler.
en
Symbols, abbreviations and terms used.
Symbol, character Explanation
Observe the instructions in the text or graphic opposite!
Make sure to read the enclosed documents such as the Instruction Manual and the General
Safety Instructions.
Before commencing this work step, pull the mains plug out of the socket. Otherwise there will
be danger of injury if the power tool should start unintentionally.
Use eye protection during operation.
Use ear protection during operation.
Use protective gloves during operation.
Gripping surface
Confirms the conformity of the power tool with the directives of the European Community.
This sign indicates a possible dangerous situation that could cause severe or fatal injury.
WARNING
Worn out power tools and other electrotechnical and electrical products should be sorted
separately for environmental-friendly recycling.
Product with double or reinforced insulation
Steel
Aluminium
Plastic
Low stroke rate
High stroke rate
Character Unit of measure-
ment, international
P W
1
P W
2
n /min, min
0
r/min
n m/min
S
U
V
f
Hz
M... mm
Ø mm
mm
Fe 400
mm
Fe 600
mm
Fe 800
mm
Al 250
mm
mm
Unit of measure-
ment, national
W
W
-1
, rpm, rpm
m/min
V
Hz
mm
mm
mm
mm
mm
mm
mm
mm
Explanation
Power input
Output
Stroke rate at no-load
Cutting speed
Rated voltage
Frequency
Size of metric thread
Diameter of a round part
Max. work-piece thickness for steel with up to 400 N/mm
Max. work-piece thickness for steel with up to 600 N/mm
Max. work-piece thickness for steel with up to 800 N/mm
Max. work-piece thickness for aluminium with up 250
2
N/mm
Diameter of pilot-drill for inside cut-outs
Min. inside curve radius
en
19
2
2
2